Jump to content

Paper of the Month

Papers in scientific journals are a crucial output of our research. They are the most important communication channel to share scientific findings and discoveries with the scientific community and to encourage a discussion thereof. Thus, papers are a substantial part of our competence as a research institute. With the series “Paper of the month” we want to call attention of a broader audience to our results.

  1. Focus area Analytical Sciences: Paper of the Month March is "Design and validation of an additively manufactured flow cell–static mixer combination…

    Additively manufactured SMX mixer evaluated through CFD simulation (left) and computed tomography (right)
  1. Focus area Infrastructure: Paper of the Month February is "A Novel Approach to Additive Manufacturing of Alkali-activated Materials: Laser-induced…

    Thermal imaging during manufacturing and finished part being lifted from the suspension
  1. Focus area Environment: Paper of the Month February is "Comparison of calcined illitic clays (brick clays) and low-grade kaolinitic clays as…

    Micrograph of a calcined brick clay with typical aggregates of platy (dehydroxylated) clay particles.
  1. Focus area Analytical Sciences: Paper of the Month February is "Wash-Free Multiplexed Mix-and-Read Suspension Array Fluorescence Immunoassay for…

    Illustration: The sample is mixed with reagents (particles and antibodies) and analyzed using a flow cytometer.
  1. Focus area Environment: Paper of the Month January is „Seasonal cooling performance of air conditioners: The importance of independent test procedures…

    Air conditioner and diagram
  1. Focus area Infrastructure: Paper of the Month January is "Aerial-based gas tomography – from single beams to complex gas distributions", published in…

    BAM Test Site for Technical Safety: Experiment for drone-assisted reconstruction of a gas plume cross section
  1. Focus area Environment: Paper of the Month January is "Fifteen years of proficiency testing of total petrol hydrocarbon determin. in soil ...",…

    Diagram
  1. Focus area Materials: Paper of the Month January is "Assessment of thermal cycles by combining thermo-fluid dynamics and heat conduction in ...…

    3D weld pool interface defined by the solidus temperature (left) and division of an exemplary weld pool interface into boundary elements (right)
  1. Focus area Analytical Sciences: Paper of the Month January is "Development of an automated on-line purification HPLC single cell-ICP-MS approach for…

    Automated single diatom analysis of Cyclotella meneghiniana via ICP-MS

BAM is a senior scientific and technical Federal institute with responsibility
to the Federal Ministry for Economic Affairs and Energy.

Cookies